Ask us anything

How to change door swing on Whirlpool Duet dryer?

Changing the door swing on a Whirlpool Duet dryer involves reversing the direction in which the dryer door opens. This can be necessary if the existing door swing doesn't suit your laundry room layout. Here's a step-by-step guide on how to change the door swing on your Whirlpool Duet dryer:

Safety Precautions:
Before you begin, ensure safety by unplugging the dryer from its power source to prevent any electrical accidents. Wear safety glasses and work gloves to protect yourself during the process.

Tools and Materials:
Gather the necessary tools and materials for the task, including:
* Screwdriver (usually a Phillips)
* Nut driver or socket set
* Workbench or a sturdy surface for working
Step-by-Step Guide:
* Unplug the Dryer:
Disconnect the dryer from its power source by unplugging it or turning off the circuit breaker.
* Prepare the Work Area:
Ensure you have a clear and safe workspace to perform the door swing reversal. You may want to lay down a blanket or some towels to protect the dryer's surface during the process.
* Open the Dryer Door:
Open the dryer door fully to access the hinge screws and components.
* Remove the Hinge Screws:
Locate the hinge screws on the dryer door and the dryer cabinet. Typically, there are two screws on each side of the hinge assembly. Using a screwdriver or a nut driver, remove these screws from both the door and the cabinet. Keep the screws, as you'll need them for reinstallation.
* Lift the Door Off:
Once you've removed the hinge screws, carefully lift the dryer door off the hinge pins. Set the door aside.
* Reposition the Hinge Receiver:
Depending on your dryer model, you may need to reposition the hinge receiver on the opposite side of the dryer cabinet to accommodate the new door swing direction. Refer to your dryer's user manual for specific instructions on how to do this. Typically, it involves removing screws or clips that hold the receiver in place and reinstalling it on the other side of the cabinet.
* Reattach the Dryer Door:
Take the dryer door and position it on the opposite side of the dryer cabinet, aligning the hinge pins with the hinge receiver. Carefully lower the door onto the pins.
* Reinstall the Hinge Screws:
Secure the dryer door to the dryer cabinet by reinstalling the hinge screws on both sides of the hinge assembly. Tighten the screws securely but avoid over-tightening to prevent damage to the door or cabinet.
* Test the New Door Swing:
Close and open the dryer door a few times to ensure that it operates correctly in the new swing direction. Verify that the door latches securely and that there are no issues with its movement.
* Plug In the Dryer:
Reconnect the dryer to its power source by plugging it in or turning on the circuit breaker.
* Run a Test Cycle:
To ensure that the dryer operates correctly with the new door swing direction, run a test cycle. Load the dryer with a small load of laundry and start a drying cycle, monitoring it for any issues.
* Final Check:
Conduct a final visual inspection to make sure that the dryer door is properly aligned, latches securely, and there are no unusual noises or problems during operation.

By following these steps, you can successfully change the door swing direction on your Whirlpool Duet dryer. Reversing the door swing can be helpful in adapting your dryer to your laundry room layout and preferences. If you encounter any difficulties or are unsure about any aspect of the process, consult your dryer's user manual or consider seeking assistance from a professional appliance technician to ensure a safe and effective door swing reversal.
Connect to virtual expert

Our virtual experts can diagnose your issue and resolve simple problems.