I'm calling to check on the status of someone coming to my house today for a service.
Just a minute, let me see. ( call cuts off after a couple of minutes with no response )
Similar Questions
Is it normal for my refrigerator to run constantly?
No, it’s not. Refrigerators have cycles such as Automatic Defrost. If it’s running constantly that means it’s not reaching a certain temperature.
How Much Do You Charge to Come Out to Do a Service Call?
With Home Alliance, you pay by the job, not by the hour. Once we discover the problem, some locations may waive the fee altogether if you decide to have us perform the full repair.
How to clean the dryer?
Turn the dryer off and unplug it. Unplug your dryer from the wall outlet before cleaning the dryer vent. Extend the dryer, then release the vent clamp. You must unscrew the clamp holding the vent pipe to the wall aperture. Depending n the clamp type, you may need to remove it with a screwdriver or press it to release it. Check for and remove vent obstructions. Clean out you're lent by vacuuming. Remove as much lint and dirt as possible from the opening's deepest point using the cleaning tool or vacuum—clear obstructions from the external vent. Remove or lift the flap or cover if your outside vent has one so you can glance inside. Use the same tools you used to clean the other side of the vent while wearing gloves to remove any obstructions or debris you can reach. Look for anything blocking the outdoor vent. Reattach the dryer vent. Lint or debris that came out while you were cleaning should be swept or vacuumed. Restart the dryer by turning on the electricity once again. Check to see if any other debris is released by letting it run for a while.
I just scheduled a visit to my home for tomorrow from 3pm to 6pm, and I was just called for a meeting outside. So can we move the meeting to Wednesday anytime?
Yes, we can go Wednesday between 2pm to 5pm, and our technician will call 30 minutes prior.
Whats happens if the generator gets overloaded?
Generators are equipped with overload protection. In the rare event of an overload, the generator’s circuit breakers will trip, disconnecting the unit from the load. Simply correct the overload and reset the breaker in the generator.
Couldn't find the right question?
You can send your question to our support team. We'll get back to you as soon as possible