I talked to the plumber, and he is coming back to install the part. But I haven't received a bill yet or the estimate yet. He told me to keep an eye out for an email which I haven't seen anything in yet.
I will go ahead and inform our manager to let our plumber know that you haven't received your estimate. They just get back to you.
Similar Questions
What’s the difference between traditional and tankless water heaters?
The main difference between traditional and tankless water heaters is the way they heat and store water. Traditional water heaters have a large tank that stores and heats a set amount of water, which is dispensed when needed. On the other hand, tankless water heaters heat water on demand as it passes through the unit, without the need for a storage tank. This can provide energy savings by only heating water as needed, rather than constantly maintaining a heated tank. However, tankless units may have higher upfront costs and may not be able to supply as much hot water simultaneously as traditional units. Additionally, installation and maintenance requirements can differ between the two types of water heaters.
What Is a Surge Protector, and Do I Need One?
A surge protector is a piece of equipment that suppresses the excess voltage in your system to prevent it from causing harm to your appliances and devices. You should get some to protect your appliances and devices from power surges.
What Are Some Simple Ways to Fix a Clogged Drain?
Clear out standing water. Remove standing water as soon as possible since it attracts insects, germs, and mold. It can be removed so that more water can be added later to flush the drain. Remove visible blockages and check garbage disposal. Put on rubber gloves and clear the garbage area, including undesirable hair and food crumbs. Try boiling water and salt or vinegar and baking soda. After a one-half cup of table salt, boiling water should be poured down the drain. Alternately, combine a cup of baking soda with vinegar, let it bubble for 15 minutes, and then pour boiling water down the drain. Mix half a cup of salt and baking soda, let it sit for a few hours, and then flush with hot water. If required, repeat these steps before contacting a plumber. Plunge it out. Try diving if the mixes with the hot water and those above don't work. Put a rag in the overflow hole of the bathtub or sink first, or cover both sides of a double sink with a cloth or stopper. This makes the seal tighter and applies pressure directly on the obstruction. After several hard plunges, flush the drain with warm water. Clean the P-trap and snake it. The P-trap is located where the sink's drainpipe curves. Underneath, place a bucket or pail to collect any water or trash. On the trap arm and assembly, loosen the slip nut and gently wriggle it free. Do not over-tighten the slip nuts—a hand tighten plus a quarter turn with a tool is secure enough—remove any impediment stuck here and reinstall. Snake the drain. Start snaking if the blockage is not apparent after removing the P-trap. Take off the P-trap to reveal the "stub out" of the pipe, then thread the snake's tip into it. Spin the snake down the drain clockwise while tightening the set screw. Keep rotating the snake when you run against resistance and the obstruction releases. Retract the snake, put the P-trap back together, and thoroughly rinse with warm water to flush the freshly opened line.
I have an appointment for this morning. I don't know when exactly, so I wanted to check when it is.
Yes, you have an appointment from 9 to 12 AM. We don't have a precise time, but I can call the technician to know his ETA.
What size wire do i need for 125 amp service?
If you have a 125 Amp breaker, you need a 125 Amp wire. Currently, there is no 90 Amp breaker, so the next best option would be to use a 75 column. Since this is only for single-phase dwellings, #2 AWG copper or 1/0 aluminum wires will do the job.
Couldn't find the right question?
You can send your question to our support team. We'll get back to you as soon as possible