Kenmore dishwasher 665, how to replace pump gasket?

Replacing the pump gasket in a Kenmore dishwasher (model 665) is a task that can help resolve leaks and improve the dishwasher's performance. The pump gasket seals the connections between the pump and other components. Here's a general guide to assist you in replacing the pump gasket: 1. Safety Precautions: To ensure safety, disconnect the dishwasher from the power supply and shut off the water supply before starting the repair. 2. Access the Pump Area: Depending on the model, you may need to remove the front kickplate, lower access panel, or the dishwasher's interior racks to access the pump area. Consult your user manual for specific instructions. 3. Drain the Dishwasher: Before proceeding, ensure the dishwasher is empty and there's no standing water in the tub. 4. Locate the Pump: The pump is usually located at the bottom of the dishwasher near the center. It's responsible for pumping water in and out of the appliance. 5. Disconnect Hoses and Wiring: * Carefully detach the hoses connected to the pump. These could include the drain hose and possibly others. * If there's any wiring connected to the pump, unplug it after taking a photo or making a note of the connections. 6. Remove the Old Gasket: * Inspect the pump for the old gasket. It might be attached to the pump housing or to the components it connects with. * Carefully remove the old gasket. Depending on its placement, it might slide out or need to be peeled off. 7. Prepare the New Gasket: * Ensure you have the correct replacement gasket. Compare it to the old one to ensure a proper fit. * If the new gasket requires adhesive, apply it according to the manufacturer's instructions. 8. Install the New Gasket: * Carefully position the new gasket in place where the old one was located. Press it firmly to ensure proper adhesion. 9. Reconnect Hoses and Wiring: * Reattach the hoses and wiring you disconnected earlier. Ensure a snug fit for the hoses to prevent leaks. 10. Test for Leaks: Turn on the water supply and run a short cycle to check for any leaks around the pump area. Keep an eye on the pump gasket during this test. 11. Reassemble the Dishwasher: If you removed any panels or components, reattach them in the reverse order. 12. Run a Full Cycle: Once everything is reassembled, run a full cycle to ensure the dishwasher operates without any leaks or issues. Keep in mind that this is a general guide, and your specific model might have slight variations. Refer to your user manual for model-specific instructions and diagrams. If you're unsure about the repair process, consider seeking the assistance of a professional appliance technician.