Ask us anything
sub zero how to reset filters if it says they are disabled
If the Sub-Zero refrigerator displays a message saying the filters are disabled, you can reset them using these steps:
1. Open the refrigerator door and locate the control panel, which is usually on the top inside the fridge compartment or on the front grille.
2. Press and hold the "Filter Reset" or "Water Filter" button for 5-10 seconds. Keep holding it until you see the filter status reset on the display.
3. Release the button once the reset is complete. The filter status should now indicate that the filters are ready to be replaced or are in their initial state.
If the "Filters Disabled" message persists or if you encounter any issues, consult the refrigerator's user manual or contact Sub-Zero customer support for further assistance.
1. Open the refrigerator door and locate the control panel, which is usually on the top inside the fridge compartment or on the front grille.
2. Press and hold the "Filter Reset" or "Water Filter" button for 5-10 seconds. Keep holding it until you see the filter status reset on the display.
3. Release the button once the reset is complete. The filter status should now indicate that the filters are ready to be replaced or are in their initial state.
If the "Filters Disabled" message persists or if you encounter any issues, consult the refrigerator's user manual or contact Sub-Zero customer support for further assistance.
Similar Questions
- How much does a 36 Thermador range weigh?
- I had one of your technicians come down, and he ordered a few parts, and he is going to come next week. I actually need more parts to be ordered so when he comes, he can replace them. Is it possible if I can tell you which part I need more? He was going to change my Sub Zero gasket. I need to order for the freezer, and I need one of those gaskets.
- My name is Doug. I want to keep it brief since you are taking many calls, but do you manage the office by chance? I was trying to reach out for an after-hours answering service. Is there anyone around that I could run it by them?
- What is the difference between a 2 way switch and a 3 way switch?
- Does the Rheem Classic Series Two Stage Heat Pump (RP16) offer effective dual-stage cooling and heating?
- How to replace burner assembly A.O. Smith gas hot water tank?
- All the switches in our condo are not working. Anything that is plugged in is working, but the switches are not. About 15 light switches aren't working. I did flip the breaker, but nothing happened.
- How do I clean and maintain the Allegiance 16 Central Air Conditioner for peak efficiency?
- Is regular maintenance recommended for the York TL9E 95% AFUE Single Stage Ultra Low NOx Furnace, and if so, what does it involve?
- How to change Pur water filter in Whirlpool refrigerator?
Similar Blog
February 04
1344
Home appliances
Granite Countertop Alternatives
If you're thinking about a kitchen renovation, you don't want to stop short. Of course, you want new cabinets and flooring, and you're dreaming of new counterto...
April 20
6849
Plumbing
Avoid Basement Floods
A basement flood can be a homeowner's worst nightmare. Not only can it cause significant damage to your home and belongings, but it can also pose a health hazar...
August 01
9539
Home appliances
How to Load a Dishwasher, the Correct Way
Each cycle of the dishwasher can be improved if it is loaded properly. It can be frustrating when you try to unload your dishes and discover that they are still...
Couldn't find the right question?
You can send your question to our support team. We'll get back to you as soon as possible