Ask us anything
Replace evaporator fan motor Kenmore Elite 795.74029.411.
Replacing the evaporator fan motor in a Kenmore Elite 795.74029.411 refrigerator is a task that requires careful disassembly and attention to detail. The evaporator fan motor is responsible for circulating air within the refrigerator to maintain consistent temperatures. Here's a general guide to help you through the process: 1. Safety Precautions: Begin by unplugging the refrigerator from the power source to ensure your safety during the repair. 2. Access the Evaporator Fan Motor Area: The evaporator fan motor is typically located in the freezer compartment behind the back panel. You may need to remove shelves, drawers, and the rear panel to access it. 3. Defrost the Freezer (if needed): If the freezer's back panel is frozen, it's a good idea to defrost it before proceeding. This can prevent damage to components and make the repair process smoother. 4. Unclip or Unfasten the Back Panel: Carefully unclip or unscrew the back panel to access the evaporator fan motor. Note the position of any screws or clips for reassembly. 5. Disconnect Wires: Before disconnecting any wires, take pictures or label them to ensure proper reconnection. Gently disconnect the wires from the evaporator fan motor. 6. Remove the Old Fan Motor: Unscrew any screws or fasteners holding the old fan motor in place. Carefully slide the old fan motor out of its position. 7. Install the New Fan Motor: Slide the new fan motor into the same position as the old one. Align it with the mounting holes. 8. Secure with Mounting Hardware: Use the screws or fasteners you removed earlier to secure the new fan motor in place. Make sure it's snug but not overly tightened. 9. Reconnect Wires: Attach the wires to the new fan motor according to your notes or photos. Ensure each wire is securely connected to the corresponding terminal. 10. Reassemble the Freezer: Reattach the back panel using the clips or screws you removed earlier. Make sure the panel is securely fastened. 11. Plug in and Test: Plug the refrigerator back in and monitor the operation of the new fan motor. Listen for its operation and ensure proper airflow. 12. Check for Abnormalities: Monitor the refrigerator's temperature over the next few hours to ensure that the new fan motor is maintaining proper cooling and airflow. Always consult your refrigerator's user manual for model-specific instructions and diagrams. If you're not comfortable with the repair process, consider seeking the assistance of a professional appliance technician.
Similar Questions
- What should be done to maintain the efficiency of the York YXT 18 SEER2 Two Stage Air Conditioner?
- How do I completely turn off my Nest Thermostat?
- What does a flashing snowflake on my thermostat mean?
- Is it worth scheduling annual maintenance for my Trane XL824 thermostat to ensure accurate temperature control?
- I called yesterday to schedule an HVAC repair service and wanted to see if I could schedule a later time than the morning time I got scheduled.
- Is it ok to connect multiple Carrier i-Vu® building automation systems for centralized control across different buildings within my complex?
- How much does it cost to replace ac compressor clutch?
- How to replace heating element in A.O. Smith water heater?
- Is there any water heater maintenance that I can do myself?
- How to replace an A.O. Smith water heater control?
Similar Blog
June 24
7093
Plumbing
How to Unclog a Bathtub Drain?
In this comprehensive guide, we're diving headfirst into the world of plumbing problem-solving to show you how to conquer the dreaded clogged sink drain like a ...
April 28
5837
Home
How often is it safe to wash clothes?
Many people are unsure of how often they should wash their clothes. The answer depends on a few factors that are important to consider. Type of Clothing Und...
August 14
837
Home appliances
Why Is My Freezer Frosting Up?
If you've noticed frost accumulating in your freezer, you're not alone. This common issue can be both puzzling and frustrating, leading many to seek out applian...
Couldn't find the right question?
You can send your question to our support team. We'll get back to you as soon as possible