How do I completely turn off my Nest Thermostat?
In the bottom-left corner, select HEAT. Depending on where you are located, it might say cool instead. Once the pop-up menu appears, select "Off." The thermostat will turn off until you turn it back on again.
Similar Questions
Why isn’t my new fridge cold?
After being plugged in, it can take 12 to 24 hours for your refrigerator and freezer to reach the desired temperatures.
How do you reset a Dishlex dishwasher?
To reset most dishwashers, press and hold the start button for three seconds. However, in a Dishlex unit, it depends on why you need to reset it. If the unit is paused, hit the start button to continue the cycle. If your machine is in delay mode, pressing and holding down the delay button for three seconds should cancel it. And if that doesn't work - don't worry! Continuously press the delay start until the time reaches its maximum limit, which will reset automatically.
How soon can I schedule a technician?
In many cases, we can be at your doorstep today. The technology behind our platform allows us to quickly find a trusted Home Alliance technician in your area and match them to your job. We often respond faster than our competitors. If you do not need a same-day appointment, we can schedule an appointment for a time that is most convenient to you. Scheduling ultimately depends on our technicians' availability and on your desired appointment time
I have spoken to somebody earlier; I'm going to have a service around 1pm through 4pm. By accident, I told my refrigerator was GE, and it is actually Whirlpool. Does that make a difference?
No, it's fine. We will just go ahead and change it here to Whirlpool.
How would I know if my toilet leaks? If it is, what should I do?
Toilet leaks occur in two ways and very often are difficult to detect. First, the most common toilet leak and often hardest to detect is caused by a deteriorated or defected flush valve (flapper) or "tank" ball at the bottom of the toilet tank. If the flapper or ball valve does not seat properly and form a water-tight seal, water will leak around it into the toilet bowl. Often, this leak will occur without being heard. Here is an easy way to check for flush valve leaks and in just minutes, you can find out if a toilet is wasting thousands of gallons due to an undiscovered water leak. Remove the tank lid, then flush. After the flapper/tank ball drops and the tank refills, add several drops of dark food coloring) or a Fluidmaster leak detector tablet. Wait at least 20 minutes. If any trace of color appears in the toilet bowl, there is a leak. The second most-common type of leak is caused by improperly adjusted or broken fill valve. If the float is set too high or the shut-off valve fails to close completely, water will continue to enter the tank and flow into the overflow tube. This type of leak can be seen simply by taking the tank top off and observing if water is flowing into the overflow tube once the tank is full. Excess water pressure can also have a negative effect on the operating system in your toilet. If you are experiencing either of these types of leaks and need service to fix them, contact our office.
Couldn't find the right question?
You can send your question to our support team. We'll get back to you as soon as possible