Ask us anything
Replace water filter on Kenmore model 106.50042 711 and reset the light???
To replace the water filter and reset the light on a Kenmore refrigerator model 106.50042 711, follow these steps: Replace the Water Filter: 1. Locate the Filter: The water filter is typically located inside the refrigerator compartment. Look for a filter housing in the upper right corner of the refrigerator interior. 2. Turn Off the Water Supply: Before replacing the filter, it's a good idea to turn off the water supply to prevent any leaks. You might have a water shut-off valve behind or beneath the refrigerator. 3. Remove the Old Filter: Rotate the old water filter counterclockwise to unlock it from the filter housing. Pull the filter straight out. 4. Prepare the New Filter: Remove the protective cap from the new water filter. Check if there's a sealing sticker or plug on the end of the filter – if present, remove it. 5. Install the New Filter: Insert the new filter into the filter housing. Align the filter's tabs with the housing's grooves. Rotate the filter clockwise to lock it in place. The filter should click into position. 6. Turn On the Water Supply: After installing the new filter, turn the water supply back on. This helps prime the filter and remove any air. Reset the Filter Indicator Light: 1. Locate the Control Panel: Find the control panel on the front of the refrigerator. 2. Check the Indicator Light: If the filter indicator light is on, it's time to reset it after replacing the filter. 3. Reset the Light: Press and hold the "Reset" button on the control panel for a few seconds. The location of the reset button can vary, so consult your refrigerator's user manual if you can't locate it. 4. Monitor the Light: After releasing the button, check if the filter indicator light turns off. If it does, the reset was successful. 5. Check the Manual: If you're unsure about the location of the reset button or if the light doesn't turn off, consult your refrigerator's user manual for precise instructions. Remember, these are general steps, and the specific process for replacing the filter and resetting the indicator light on a Kenmore model 106.50042 711 refrigerator might vary. Always consult your refrigerator's user manual for accurate and model-specific instructions. If you encounter any difficulties, consider contacting Kenmore's customer support for assistance.
Similar Questions
- How to replace thermocouple on A.O. Smith gas hot water heater?
- How can I flush the heat exchanger on my Takagi TK-110U-E unit?
- How can I tell I need an air duct cleaning?
- Where is the reset button for Kenmore upright vacuum model 116-31140311?
- How to replace the fan motor in my Lennox SLP99V Variable-Capacity Gas Furnace?
- How much water does a hose put out per hour?
- What should be the best practices for venting a Rinnai REP Model Series tankless water heater, such as the REP160eP, in a residential setting?
- What are some signs that my tap water might be contaminated?
- Should I schedule regular maintenance checks for my Goodman geothermal heat pump system?
- How can I incorporate a Goodman hybrid heat pump system into my existing HVAC setup?
Similar Blog
April 19
8756
Home appliances
8 Common Signs Your Refrigerator Is Dying
Welcome to the world of modern-day living, where refrigerators have become an integral part of our lives. It's easy to take for granted the convenience it provi...
August 19
9326
Home
Why Does My House Smell Musty? Causes and Solutions
Step into your home, close the door behind you, and take a deep breath – but wait, is that a musty odor lingering in the air? The comfort of home can sometimes ...
February 18
684
Electrical
How to Adjust Outdoor Lighting for Every Season
The right lighting can transform your outdoor space, but as the seasons change, so should your approach to illumination. Whether it’s creating a warm glow for w...
Couldn't find the right question?
You can send your question to our support team. We'll get back to you as soon as possible