How to fix model 110 Kenmore dryer belt replacement?

Replacing the belt in a Kenmore model 110 dryer is a relatively straightforward process that can be done with some basic tools and careful attention to detail. Here's a step-by-step guide to help you through the process: 1. Safety Precautions: Before beginning any appliance repair, ensure that the dryer is unplugged from the electrical outlet to prevent accidents. 2. Access the Interior: * Remove the lint screen and any screws securing the lint screen housing. * Use a putty knife to release the clips holding the top panel in place. Lift the top panel and prop it up securely. 3. Remove the Front Panel: * Disconnect the door switch wires. * Locate and remove the screws that secure the front panel to the sides of the dryer cabinet. * Carefully pull the front panel away from the cabinet and set it aside. 4. Access the Belt: * Locate the drum and motor assembly. * The drum is supported by a pulley system. The belt should be wrapped around the drum and looped around the motor pulley and idler pulley. 5. Remove the Old Belt: * Release the tension on the belt by moving the idler pulley away from the belt. * Slip the old belt off the motor and idler pulleys. 6. Install the New Belt: * Place the new belt around the drum in the same position as the old belt. * Route the belt around the motor pulley and idler pulley. Ensure the grooved side of the belt is against the drum. 7. Reassemble: * With the new belt in place, reattach the front panel by securing it with screws. * Reconnect the door switch wires. * Lower the top panel and secure any clips that hold it in place. * Reattach the lint screen housing and lint screen. 8. Test: * Plug the dryer back into the electrical outlet. * Run the dryer on a low heat setting to ensure the belt is tracking properly and the drum is turning smoothly. Remember, safety is crucial when working with appliances. Always unplug the dryer before performing any repairs. If you're unsure about any step, refer to the dryer's manual or consider seeking professional assistance. Following these steps should help you successfully replace the belt in your Kenmore model 110 dryer, restoring its functionality and efficiency.